(II) An 18.0-kg monkey hangs from a cord suspended from the ceiling of an elevator. The cord can withstand a tension of 215 N and breaks as the elevator accelerates. What was the elevator's minimum acceleration (magnitude and direction)?

(II) What will a spring scale read for the weight of a 58.0‑kg woman in an elevator that moves

(b) downward with constant speed 4.4 m/s,

(II) What will a spring scale read for the weight of a 58.0‑kg woman in an elevator that moves

(d) with a downward acceleration 0.18 g, and

(II) An exceptional standing jump would raise a person 0.80 m off the ground. To do this, what force must a 68-kg person exert against the ground? Assume the person crouches a distance of 0.20 m prior to jumping, and thus the upward force has this distance to act over before he leaves the ground.

(II) What will a spring scale read for the weight of a 58.0‑kg woman in an elevator that moves

(e) in free fall?

(III) Determine a formula for the acceleration of the system shown in Fig. 4–49 (see Problem 55) if the cord has a non-negligible mass m_C . Specify in terms of ℓ_A and ℓ_B , the lengths of cord from the respective masses to the pulley. (The total cord length is ℓ_A + ℓ_B.) <IMAGE>

"(II) High-speed elevators function under two limitations: 

(1) the maximum magnitude of vertical acceleration that a typical human body can experience without discomfort is about 1.2 m/s², and 

(2) the typical maximum speed attainable is about 9.0 m/s. You board an elevator on a skyscraper's ground floor and are transported 180 m above the ground level in three steps: acceleration of magnitude 1.2m/s² from rest to 9.0 m/s, followed by constant upward velocity of 9.0 m/s, then deceleration of magnitude 1.2m/s² from 9.0 m/s to rest. 

(a.) Determine the elapsed time for each of these 3 stages."

(III) An inclined plane, fixed to the inside of an elevator, makes a 38° angle with the floor. A mass m slides on the plane without friction. What is its acceleration relative to the plane if the elevator

(d) moves upward at constant speed?

(II) A narrow but solid spool of thread has radius R and mass M. If you pull up on the thread so that the cm of the spool remains suspended in the air at the same place as it unwinds,

(a) what force must you exert on the thread?